Ubiquiti UniFi HD In-Wall 802.11ac Wave 2 Wi-Fi Access Point 4 Port Ethernet Switch, UAP-IW-HD

Product Information

Approximate maximum EIRPs for each AP. Actual Transmit power and gain may be lower depending on your channel width, frequency, and specific hardware details. To get your AP's exact Tx power level run iwconfig in an ssh session. Gain values are relative to a theoretical perfect omnidirectional antenna, and are subject to the radiation patterns of the antennas in the device. PoE+ input is required to use PoE passthrough. Connect this port to a UniFi Switch with PoE that is connected to your LAN and DHCP server. Four ports are available for bridging – one of which offers PoE passthrough when the AP is powered by an 802.3at PoE+ switch.

Ubiquiti UAP-IW-HD UniFi In-Wall Wi-Fi Access Point

The quoted wireless specification is given as the maximum radio performance. Achievable range and throughput will vary depending on the regional regulations where the radio is deployed.

System Requirements

Regional regulations must be observed when deploying radio equipment. More info Power Input PoE Min Please note that these radiation patterns are gathered in a fully anechoic environment. Their shape, peak gain/directivity and efficiency will change in installed environments. Every deployment will behave differently due to interference, materials, geometries of structures, and how these materials behave at 2.4GHz and 5GHz. Use this table to compare the radiation patterns of each UAP. The first column shows where the respective colored dots found in each radiation plot is placed in the actual devices. Note that colored dots in the plots might be in the outer perimeter or closer to center.

UniFi IW HD AP Datasheet - Ubiquiti

The UAP-IW-HD is powered by 802.3af PoE. If PoE passthrough is being utilised, 802.3at PoE is required.The only thing odd to me so far is UniFi shows wired clients connected to my main switch (US-16-150W) instead of UAP-IW-HD. I have a printer and a NAS box plugged into the UAP-IW-HD. UniFi shows them connected to the main switch's port feeding the UAP-IW-HD. While technically correct, it would prefer it show then connected to the UAP-IW-HD. Ethernet port supports data and PoE passthrough (requires 802.3at PoE+ input). The maximum PoE passthrough output is 12W. Ubiquiti UniFi AP IW HD (In Wall) is an 802.11ac Wave2 MU-MIMO access point that is ideal for hospitality or multi-room deployments. The UAP-IW-HD provides 4x4 MIMO at 5GHz and 2x2 MIMO at 2.4GHz for a combined PHY rate of 2033Mbps. Use this article to compare the different antenna radiation patterns of our UniFi Access Points. About Radiation Patterns

UAP-IW, UAP, UAP-LR, UAP-PRO, - Ubiquiti Models: UAP-IW, UAP, UAP-LR, UAP-PRO, - Ubiquiti

This item comes without PoE injectors and must be bought seperately if you are not using them with a PoE Switch.Note: Varying scales are represented in the graphs below. Consider each graph individually and take note of scale when comparing products.