Seagate ST2000VM003 Pipeline HD 2 TB 3.5-Inch Internal Hard Drive - Black

Product Information

If the drive is connected to your Mac, you can use the Apple System Profiler to determine the model number and serial number. Obviously 4 years old and may have been recycled from somewhere or left on an OEM shelf then resold.

Seagate ST2000VM003 - HDD FAQs Seagate ST2000VM003 - HDD FAQs

SEAGATE 1TB HDD - SIM Error 1002 LBA 0000000000045D8C FD FCFFF3FF RW Error 44440080 PowerState = IDLE1 If your drive is connected to your computer: Seagate has created a very simple tool that will tell you the serial number and the model number of any and all Seagate, Samsung and Maxtor-brand drives connected in or to your computer. Use the DriveDetect.exe method to find both numbers. The 'gfdisk -lu /dev/sda' showed that the reformat had tweaked the partition start points a little - post (maint menu) reformat it is now:terabytes capacity is perfect for archiving large-scale projects and maintaining data integrity. Supports high-definition multimedia content without compromising performance. From Factor: ST2000VM003 Seagate 3.5″ hard drive with a storage capacity of 2TB and featuring a SATA interface. ST2000VM003 Seagate Pipeline 2TB 5900RPM SATA 6Gb/s 64MB Cache 3.5-inch Hard Drive. Product images are for illustrative purposes only therefore the delivered product may vary from the one shown above. Let me know if there is anything else I can run - I will send or post any output as files unless very short. repeats but with different 'First error LBA' entries (3521602976,3521602968,3521602960 etc.) up to ...

ST2000VM003-1ET164 with Firmware SC11 - SMARTHDD Parameters of ST2000VM003-1ET164 with Firmware SC11 - SMARTHDD

Disk problems continued, however and I ran fix-disk again but it seemed to go into an infinite loop in that it kept finding new bad sectors (like in the above messages) and resetting its count-down counter to 1520ish every time, so looked like it was never going to finish. After around 36 hours I gave up, rebooted, and ran the maint menu reformat option, deleting everything. I don't have anything very precise to measure them with unfortunately, especially under load and normal working. The disk failed again a while later and I did not get round to doing anything about it until recently, when I bought a 2TB Seagate Pipeline and popped it in. No obvious hardware issues on the install. Repeating short and cryptic messages from the diagnostic without further 'aha - that means this definitive disastrous disk condition is extant', or just pointers to useful docs or explanations, does not really move things forward.So, is there anything else I can usefully try such as tweaking the e2fs parameters, or does it look like my brand new disk is just faulty ? These threw out problems, and I accepted and reset, but they returned. I then went into the maintenance menu and tried short and long and fix-disk, but still had issues. Lyve: Periferie-naar-cloudplatform voor massaopslag Lyve Cloud: Voordelige objectopslag, ontworpen voor de multicloud

Pipeline HD Data Sheet - Seagate

The Seagate Pipeline ST2000VM003 which others have found a good replacement 2TB drive is now discontinued, but I persisted.

Firmwaredownloads

This 7200RPM desktop hard drive is specifically designed for maximum performance. It delivers exceptional speed and responsiveness which make it ideal for enterprise-level applications, intensive data processing, and tasks that demand the highest level of performance and reliability. Interface: