ESI ES2247B 2-Channel Multi Purpose Programmer (New Model)

Product Information

a TX Module with version string of 3.1.2 will sync and work with a Receiver with firmware version 3.0.1

SPI-based Receivers on Betaflight 4.4.0 and newer will only sync or bind with ExpressLRS 3.x firmware

Ask a question

With the release of ExpressLRS v3.0, updating your Binding Phrase via the WebUI is an even more compelling reason to use a Binding Phrase.

If there is no other Full UART, you can try wiring a Pull-up Resistor: Connect a Resistor (300 Ohm to 1k Ohm value; a lower value is more effective) between this UART's RX pad and either a 5v or 3.3v pad as shown below: The new range of programmers hold a 3-year guarantee for consumer and installer peace of mind and are focused on value, quality and simplicity, offering an economical and durable solution for households. If you are using any of the Digital FPV systems like the DJI FPV Air Unit, Caddx Vista or DJI O3 Air Unit, and you wired or connected all six wires to your Flight Controller, you will need to remove the SBUS/DJI HDL wire. Using the ExpressLRS Lua Script, look for a C in the top-right corner of the screen which indicates TX module and Receiver are Connected and Communicating. a TX Module with version string of 3.2.0 will NOT sync or bind with a Receiver with firmware version 2.4.0Power up your transmitter/radio and use the [BIND] button on the ExpressLRS Lua script, which sends out a binding pulse. The Popup will briefly show up and then disappear. The ES2247B is a two channel multi purpose programmer with the flexibility of two or three on/off timings per day and can be configured for 7 day, 5/2 day or 24 hour operation for independent channels (all within the one unit), allowing one product to suit all installations alleviating any potential of incorrect selection. Binding can be done with either a hard-coded unique Binding Phrase or in a more traditional way where you put the receiver and transmitter into bind mode, and they link up. If you'll be updating or reflashing your ExpressLRS firmware into your device anyway, using a Binding Phrase is a no-brainer. The ESi Controls 2 Channel Programmer offers flexibility and reliability for use in any domestic heating and hot water installations. The ES2247B is a twin channel multi purpose programmer, designed for separate control of your heating and stored hot water. The heating and hot water programmes are independent of each other, giving you the opportunity to operate the system in the most energy efficient and cost effective manner.

A Receiver flashed or set with a Binding Phrase WILL NOT initiate Manual Binding mode, however many times you try the procedure below. You must first reflash the receiver with the Binding Phrase field disabled and/or unset. Why would you not use a bind phrase though if you're already having to flash the RX anyway?However you say "Turned the thermostat right down but heating stayed on." which does not seem to point to the programmer. Selecting the most suitable type of Heating Control is an important decision. Once you determine that Programmers & Time Switches are the best solution then the ESi 2 Channel Multi-Purpose Programmer - ES2247B is assuredly worth factoring in to your final decision. It is designed primarily for separate control of your heating and stored hot water (S or Y plan). The heating and hot water programmes are independent of each other, giving you the opportunity to operate the system in the most energy efficient and cost effective manner.