LIGHTAILING Light Set For (Ghostbusters Ecto-1) Building Blocks Model - Led Light kit Compatible With Lego 21108(NOT Included The Model)

Product Information

Take the front grey pole with attached lights and disassemble all the pieces as we will be replacing the grey pieces with new pieces (with different clips). Before dive into the KIT itself I have to remark, that the customer service was just fantastic before buying the KIT. I had some doubts and questions but they were just provided one of the best support online. Take 1 standard Bit Light (non flashing) and place it on top of the stud of the grey round plate ensuring the LED component part is facing the correct way up. Secure the LED in place by connecting the transparent Lego plate over the top. Connect the cables from the tail lights into one of the 12-port expansion boards ( expansion board#1) by first winding them around the board before connecting them into the first 2 available ports. We are winding them around the board so that we don’t have too much excess cabling to have to hide later on. One 3-Voice Polyphonic Sound Chip with Ecto-1 Siren, Engine, Door, and Alarm Sound EffectsPre-Loaded

CAUTION: Forcing LEGO® to connect over a cable can result in damaging the cable and light. Connecting cable connectors to Expansion Boards

LEGO® Ideas

Take 1 flashing Bit light and place it on top of the grey stud closest to the outside of the plate ensuring the LED component part is facing the correct way up. Secure this in place by connecting one of the provided transparent blue 1×2 plates over the top. Repeat this for the light on the other side ensuring the LED is installed to the stud closest to the outside and the LED component is facing the correct way up. Take the white 4×4 plate with pieces attached and disassemble the pieces as we will be replacing the 2 grey pieces. To ensure a trouble-free installation of your light kit, please read and follow each step carefully. Follow LeLightGo step-by-step instruction to light up your Ghostbusters ECTO-1, something amazing will happen at night. All our kits are plug and play - no electronics knowledge needed!

Before we hide the 2 cables from the right we will first install an LED to the blue light at the right side window. To do this, remove this section at the grey stud with clip. This LEGO light up kit contains lighting features such as flashing sirens on the top of the Ecto-1, front and rear headlights, and flashing emergency lights at the rear of Ecto-1. Installation Guide Take another expansion board ( expansion board#2) and connect the first group of 6 lights from the front section of the roof to the first available ports on the expansion board.Take the 2 provided Lego 1×6 white pieces and connect them underneath the roof securing the front and middle roof sections together. Reconnect the 2×6 plate to the rest of the roof, without the white plate underneath. Then remove the red light with white stud underneath so we can install another flashing Bit Light to it. Genuine LEGO® Parts for the Movie-Accurate Replacement Roof Strobe, Motor, and to Hold Adapters and Controllers in Place Our light kits come with detailed, step-by-step installation guides to help you add lights to your favourite models. No electronics experience required! Connect multiple kits